Technical Specifications:
Line Input:
- Impedance 1MW each side, 2MW differential
- Sensitivity: 7mV to 2.6V rms (-40dBu to +10dBu)
- Balanced signal input on 6.3mm 3-pole jack socket
- Common mode rejection better than 50dB below 500Hz
Slave Input:
- Impedance 33kW Sensitivity 1V rms, +2.2dBu
- 6.3mm 2-pole jack socket
Slave Output:
- Source Impedance 1kW Output level 1V rms +2.2dBu
- 6.3mm 2-pole jack socket
Loop Current:
- 9.6A Peak signal current into a SINGLE TURN LOOP.
- Metering of peak current via front panel LEDs with intervals of 3dB
Loop Resistance:
- Must be less than 2W but greater than 0.4W
Compression:
- Compression range 30dB before overload
- Front panel indication of compression level
- Efficiency: less than 0.25dB output change for 25dB input change
- Attack and Decay time constants optimized for speech
Frequency Response:
- 80 to 10kHz ± 1.5dB at low level, measured as loop current
- High frequency high signal level response is a dynamic variable and is a function of loop size, loop current, and signal content to insure no RFI generation
- Internal time constants are very short
Pre-amp power:
- ±15V DC regulated output up to 0.3A
AC Power Input:
- 110-120 Volt AC, 50 - 60 Hz or 230 Volts AC, 45 - 65 Hz
- Factory setting of voltage selection
Dimensions:
- Length: 432mm / 17 in
- Depth: 220mm / 8.7 in
- Height: 88mm / 3.5 in
- Rack mount requires 2U and RM9 Rack mount kit (optional)
Weight:
- 5.5Kg (12.2 Lb.)
The AMPETRONIC ILD9 Induction Loop Driver carries a 5 year warranty.
Copyright © 1999 AssistiveAudio. All rights reserved.
Information in this document is subject to change without notice.
Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders